Welcome! Log In Create A New Profile

Advanced

Re: I wouldn't worry about the friction drag on the ground balance control....

October 12, 2020 02:55PM
Quote
Hombre
I turn it on and set Sens. at 10, then I put the Bandido in Auto-Tune all metal and adjust for a just audible Threshold hum. then lower coil tfrom 8 inches to 1 inch above ground on a clean metal free piece ground. Use a brisk up and down motion and note what the threshold does. If the Threshold gets louder as coil approaches ground turn GB knob counterclockwise a little at a time under there is no noticeable rise of Threshold hum...... if it get quiet as coil nears ground turn clockwise a little at a time until you get a neutral setting,,,,,,easy as that.

Hi Hombre !

Thanks for your brief and easy-to-understand setup for the Bandido II µMax. smiling smiley

I'll be trying it next time out.

ToddB64
Subject Author Views Posted

GB'ing BandidoIIµMax and Clock Position of Dial Indicator when "drag" is felt.

ToddB64 68 September 27, 2020 06:01PM

I wouldn't worry about the friction drag on the ground balance control....

Hombre 44 October 10, 2020 08:59PM

Re: I wouldn't worry about the friction drag on the ground balance control....

ToddB64 30 October 12, 2020 02:55PM

ToddB64, some quick replies that might be helpful.

Monte 45 September 28, 2020 09:05AM

Re: ToddB64, some quick replies that might be helpful.

ToddB64 37 September 28, 2020 11:30AM

Re: ToddB64, some quick replies that might be helpful.

GeoW 37 September 28, 2020 07:19PM

Re: ToddB64, some quick replies that might be helpful.

ToddB64 22 October 12, 2020 04:53PM

Re: GB'ing BandidoIIµMax and Clock Position of Dial Indicator when "drag" is felt.

SvenS 53 September 28, 2020 02:40AM

Re: GB'ing BandidoIIµMax and Clock Position of Dial Indicator when "drag" is felt.

ToddB64 24 October 12, 2020 03:33PM



Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 7
Record Number of Users: 13 on January 18, 2018
Record Number of Guests: 356 on August 30, 2020