POT references -
| October 28, 2020 11:49PM |
|
Hey Todd,
I think that CB was a typo of GB or Ground balance. Maybe not. It could read either way. The Silver Sabre µMax has an adjustable Ground Balance setting. It just isn't readily accessible as it is inside the housing on the circuit board and is a small potentiometer that is typically SET at the factory using the assigned coil and a sample piece of mineral.
Rich -
----------------------------------------------------
Just One More Good Target Before I Go . . . .
800 / Deus
I think that CB was a typo of GB or Ground balance. Maybe not. It could read either way. The Silver Sabre µMax has an adjustable Ground Balance setting. It just isn't readily accessible as it is inside the housing on the circuit board and is a small potentiometer that is typically SET at the factory using the assigned coil and a sample piece of mineral.
Rich -
Quote
ToddB64
Re: ToddB64, some quick replies that might be helpful.
10/28/2020 02:33PM
Hi Monte !
As one version of the saying goes “The only stupid question is the one not asked.”.
In your paragraph below, copied from your subject post, I assume the abbreviation CB 'pot' stands for Circuit Board.....Right ?
The important things to know is that the CB 'pot' should be adjusted for a proper or functional GB setting as described because:
A.. It is functional for BOTH the Threshold-based All Metal mode and the Silent-Search Discriminate mode.
B.. It should have a functional GB for any type of site you plan to search for peak performance and eliminate falsing.
Thanks,
Toddb64
----------------------------------------------------
Just One More Good Target Before I Go . . . .
800 / Deus
Sorry, only registered users may post in this forum.
Online Users
Guests:
16
Record Number of Users:
13
on January 18, 2018
Record Number of Guests:
859
on February 28, 2021