Welcome! Log In Create A New Profile

Advanced

Re: Coil height is always something I stay aware of.

September 10, 2020 05:04PM
Yes I agree and usually do work my coil an inch to 2 inches off the ground. But 4 inches is a little much IMO but if it works and that's the only metal detector you have on hand at the time then do it. I'm hoping Garrett comes out with a smaller coil sooner rather than later. I really am liking the ergonomics of the Apex and would love to keep using it.

Andrew

XP Deus-XP ORX-Minelab Equinox 800-Minelab GPX 4000-Tarsacci MDT 8000--Easy Radar ER500A GPR
Subject Author Views Posted

A Garrett Apex Video: 'Unerstanding Iron Masking and Target ID.'

Monte 221 September 10, 2020 09:32AM

Re: A Garrett Apex Video: 'Unerstanding Iron Masking and Target ID.'

Kickindirt 151 September 10, 2020 02:35PM

I just did another re-test of the Apex w/Viper on the Nai Board ... measured.

Monte 177 September 10, 2020 06:49PM

Re: I just did another re-test of the Apex w/Viper on the Nai Board ... measured.

Druid 164 September 10, 2020 08:32PM

Re: A Garrett Apex Video: 'Unerstanding Iron Masking and Target ID.'

diggindeep 153 September 10, 2020 04:59PM

Re: A Garrett Apex Video: 'Unerstanding Iron Masking and Target ID.'

diggindeep 154 September 10, 2020 12:42PM

Coil height is always something I stay aware of.

Monte 169 September 10, 2020 04:26PM

Re: Coil height is always something I stay aware of.

diggindeep 147 September 10, 2020 05:04PM

Re: Coil height is always something I stay aware of.

WM6 137 September 16, 2020 02:54PM

Re: Coil height is always something I stay aware of.

Druid 118 September 16, 2020 08:46PM



Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 59
Record Number of Users: 13 on January 18, 2018
Record Number of Guests: 859 on February 28, 2021