Welcome! Log In Create A New Profile


Factory Flush -

November 15, 2018 11:23PM avatar

I have to say that the entire v.1.5 and v1.75 would be a whole lot easier to determine if I was experiencing some sort of a fatal flaw with my detector. Then it is easy, does the new software fix it or not?

Here is what Minelab lists as 'fixes'.

ID's for sliver coins on edge have been improved, the depth gauge is more accurate and stable at all depths, and general improvements to the user interface and user profile functions.

So, I've been dabbling around again in v1.5, that last couple days, but I think I am going to switch back to the v1.75 with a full memory wipe and go from there.

I spent a good 45 minutes a couple nights ago going through each mode documenting my settings. I use Park 1 and Park 2 the majority of the time. Occasionally I run Gold 2 when I'm tot lot'ing for small bits of jewelry. Haven't delved into either of the Beach modes yet and had minimal time with Field 1 and 2.

So if the weather holds for a week or so without freezing me out, I will likely get a few more outings before I am cabin bound. Once bound, I'll be contacting Minelab about the wee bit of shaft wobble going on between the upper and mid sections of search rod. Nuisance for sure, but not enough to halt during detecting season. Winter is the perfect time to get this resolved.

Rich -


Deus - All Purpose
800 - All Purpose
CoRe - Special Purpose
MXT All Pro - reassigned to special duty in Oregon
XLT e-series - Special Purpose enroute
Subject Author Views Posted

Minelab Equinox 800 / 600 Software Upgrade . .

UtahRich 496 September 06, 2018 10:33PM

Re: Minelab Equinox 800 / 600 Software Upgrade . .

Druid 312 November 06, 2018 10:51PM

Re: Minelab Equinox 800 / 600 Software Upgrade . .

UtahRich 313 November 11, 2018 12:52AM

Re: Minelab Equinox 800 / 600 Software Upgrade . .

Druid 320 November 11, 2018 11:44AM

Factory Flush -

UtahRich 315 November 12, 2018 06:41PM

Re: Factory Flush -

Druid 246 January 07, 2019 02:02PM

Re: Factory Flush -

D&P-OR 322 November 12, 2018 08:13PM

Factory Flush -

UtahRich 273 November 15, 2018 11:23PM

Re: Factory Flush -

D&P-OR 305 November 16, 2018 01:15PM

Deep Franklin Half

UtahRich 228 January 04, 2019 11:58PM

Software All Refreshed, Cleaned Up and Ready to Go.-

UtahRich 257 November 16, 2018 09:19PM

Minelab Equinox Software Upgrade . .

UtahRich 341 November 06, 2018 04:42PM

Minelab Equinox 800 / 600 Software Upgrade . .

UtahRich 324 September 25, 2018 05:04PM

Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 11
Record Number of Users: 13 on January 18, 2018
Record Number of Guests: 302 on March 10, 2018