Welcome! Log In Create A New Profile

Advanced

Re: This machine looks familiar

November 18, 2020 08:45PM
Zincoln ....

.... when I bought Spectra Vision on the way back from Spain on the way back in September ..from a colleague who owned 4 Spectra together and said that Vision is the best ... I knew I was going to test Vision for Mike in a while .. Test field Top Digin ,, to find out .. how this detector can handle the latest Top detectors .. which have been tested several times on various coils ,,,

The top Diggin test field .. is mineralized and contaminated with iron, as well as ceramics, coke and burned nails and pieces of coal suggest that there was a fire in this place in the distant past ..... so this test field is quite similar to the roman civilization sites. ..

The test field turned out to be really challenging for Vision - because it worked well there and only Ground filter 10hz Band or 12.5 hz Band ..., and I tested Vision for several hours on 3 reels:
6x10 "Sniper, 12x10" SEF, and 13 "Detech Ultimate ..

The best results were obtained by Vision on a 12x10 "coil at the optimal setting of 3Fmulti- Best data, RxGain 6-7..DS 92 ,, allmetal 80, ground filter 12.5hz band .., sat 35-40., Recovery delay 30 ..- which sent out the best in terms of good depth and separation..in the test .., and TX Bost ON ... also did his job in depth and also sensitivity to small gold targets..so I would never have achieved the results on the increased RX Gaine at 12 ...

I would like to remind you that during the test of Depot 450 grams of silver at 80-85 cm ... Spectra Vision did not have a problem sending targets for recovery delay 10 ..- but the signal was already much shorter ..

Now for the Results ... Mike estimates, Vision would have scored about 90 points ... out of 150max.
Vision is deep and had an excellent ID at this setting, but did not hit several separation targets that were difficult to separate. , of which there are several in this field and either they are naturally camouflaged or they are camouflaged by additionally stored iron or coke.

Other coils:
The Mars Sniper 6x10 "coil did not hit several deep targets, or targets in 3D separation ... and obtained significantly less good results ..

Coil 13 "Ultimate was not bad .. but it did not show data for some targets masked by surrounding iron, as well as some separation targets .. this coil worked best on 10 hz band filters .. because on 12.5 hz band filters. The coil was throttled ... as if he started to miss certain goals reach ...
The rest of the setting turned out to be good, as before .. for the coil 12x10 "SEF ..
-------------------------------------------------- -------------------------------------------------- ---------

While testing ..Vision, I communicated with the signal to Mike .. who had some time on the test field of the V3i spectrum and the surrounding terrain .. a total of about 60 hours .. and we came to the same conclusions regarding the correct setting of the Spectra on this terrain ..
-------------------------------------------------- -------------------------------------------------- ------------

Now to Alter71 ... I tested Alter for less than an hour with 3D iron Test, as well as on the Test Field .. on a 23cm DD spool, on my "super ID" program .. I chose a 23 cm DD spool therefore. .because I consider it so far to be the most optimal depth-separation coil for such terrain .. Separation in the 3d Iron test was shown at the level of Deus .. and on the settings from the iron test the whole test continued.

The settings of Alter..and the coil did not disappoint me and according to Mike the detector would get around 130 points out of 150 max. In these depth and separation tests.

in addition, he managed to get a signal in a blind test on 2 unmarked Roman silver coins on a certain part of the terrain on the side of the test field.

ALTER 71 was set in the test for recovery 7, sensitivity 85,, mask 2. and frequency 18.4 khz .. sat 20, audio gain to 55 .. my proven settings for coil 23cmDD ..
Subject Author Views Posted

Comparison Tests ... They can be interesting, and here's a 're-test' I'm doing.

Monte 375 November 16, 2020 05:54AM

A report of a lot of detectors using their 'standard' search coil.

Monte 333 November 19, 2020 07:46AM

Any Thoughts of tossing some Rusty Tin in the Mix ?

UtahRich 202 November 19, 2020 04:34PM

Rusty Tin? Yes, it's on the agenda.

Monte 415 November 19, 2020 05:15PM

Rusty Tin - the bane of the ghost towns.

UtahRich 179 November 20, 2020 01:48AM

Rich, my thoughts regarding your thoughts.thinking

Monte 196 November 20, 2020 05:40AM

Re: Rusty Tin? Yes, it's on the agenda. Attachments

Kickindirt 197 November 19, 2020 11:00PM

No, I'm not kidding, if you read what I said or implied.

Monte 201 November 20, 2020 04:08AM

Re: No, I'm not kidding <--- lol where's your sense of humor

OregonGregg 180 November 20, 2020 12:57PM

Where's your sense of individuality ?

UtahRich 177 November 20, 2020 04:15PM

Re: Where's your sense of individuality ?

OregonGregg 190 November 20, 2020 04:53PM

Exactly! Confront it, learn it and YOUR detectors, and the future will be brighter. N/T

Monte 183 November 20, 2020 08:08PM

Sending you a PM - winking smiley N/T

UtahRich 159 November 20, 2020 06:25PM

Well Thank ya....sent you one to. N/T

OregonGregg 175 November 20, 2020 07:00PM

Still busy testing, but will have two upcoming comparisons.

Monte 224 November 17, 2020 02:02PM

Re: Still busy testing, but will have two upcoming comparisons.

D&P-OR 244 November 17, 2020 03:22PM

OregonGregg being a pain in the behind again sad smiley

OregonGregg 479 November 16, 2020 08:09AM

Gregg, I think you forgot .....

Monte 289 November 16, 2020 01:31PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 255 November 16, 2020 12:46PM

What's going to happen with the M6 ?

UtahRich 253 November 16, 2020 06:59PM

Re: What's going to happen with the M6 ?

OregonGregg 236 November 16, 2020 07:09PM

Re: What's going to happen with the M6 ?

EL NINO 223 November 17, 2020 06:13AM

Re: What's going to happen with the M6 ?

OregonGregg 448 November 17, 2020 07:49AM

Handle angle

SvenS 199 November 17, 2020 05:56PM

Re: Handle angle

OregonGregg 183 November 17, 2020 06:33PM

Re: Come on down Gregg!!

Kickindirt 194 November 17, 2020 01:39PM

Re: Come on down Gregg!!

OregonGregg 174 November 17, 2020 02:33PM

Re: Come on down Gregg!!

Kickindirt 206 November 17, 2020 04:19PM

Re: Come on down Gregg!!

D&P-OR 218 November 17, 2020 05:29PM

Re: Come on down Gregg!!

Kickindirt 185 November 17, 2020 06:05PM

Re: Come on down Gregg!!

D&P-OR 177 November 17, 2020 07:18PM

Re: ya Del

Kickindirt 185 November 17, 2020 09:00PM

I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

Monte 219 November 17, 2020 02:15PM

Re: I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

OregonGregg 184 November 17, 2020 02:37PM

Re: I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

D&P-OR 218 November 17, 2020 03:08PM

Did I read this correctly? Meet at Del & Patsy's for a winter long hunt ?

UtahRich 170 November 18, 2020 09:42PM

Re: Come on down Gregg!!

D&P-OR 207 November 17, 2020 01:45PM

Re: Come on down Gregg!!

OregonGregg 216 November 17, 2020 02:34PM

Re: What's going to happen with the M6 ?

Kickindirt 249 November 16, 2020 08:53PM

Re: What's going to happen with the M6 ?

OregonGregg 234 November 16, 2020 09:23PM

Re: What's going to happen with the M6 ?

Kickindirt 192 November 16, 2020 10:23PM

Here ya go

OregonGregg 246 November 16, 2020 10:42PM

That's not the response I expected . . . . . thinking

UtahRich 225 November 16, 2020 09:10PM

Re: That's not the response I expected . . . . . thinking

D&P-OR 227 November 16, 2020 09:25PM

So is Patsy there too ?

UtahRich 209 November 16, 2020 09:30PM

Re: So is Patsy there too ?

D&P-OR 458 November 16, 2020 09:42PM

Dinner Bell

UtahRich 259 November 16, 2020 09:44PM

confused smiley

UtahRich 262 November 16, 2020 08:32PM

The M6 - We need some clarification with your results.

UtahRich 305 November 16, 2020 07:14PM

Re: The M6 - We need some clarification with your results.

OregonGregg 249 November 16, 2020 08:11PM

OregonGregg being a pain in the behind again sad smiley

UtahRich 245 November 16, 2020 10:38AM

Rich, a few comments back to you.

Monte 239 November 16, 2020 01:21PM

What's Your Detector IQ ?

UtahRich 190 November 16, 2020 07:40PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 189 November 16, 2020 12:17PM

Re: OregonGregg being a pain in the behind again sad smiley

Druid 191 November 16, 2020 11:28PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 210 November 17, 2020 05:46AM

Re: OregonGregg being a pain in the behind again sad smiley

Druid 170 November 18, 2020 12:00PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 177 November 18, 2020 02:54PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 185 November 18, 2020 01:39PM

This machine looks familiar

zincoln 166 November 18, 2020 04:05PM

Re: This machine looks familiar

EL NINO 178 November 18, 2020 08:45PM

Thx for sharing

zincoln 170 November 18, 2020 10:44PM

Re: Thx for sharing

EL NINO 172 November 19, 2020 03:35AM

Setting Up Tests for your own detectors -

UtahRich 225 November 16, 2020 07:30PM

Agree 100%

OregonGregg 186 November 16, 2020 11:08AM

Customizing a Test -

UtahRich 223 November 16, 2020 06:52PM

Re: Agree 100%

Kickindirt 326 November 16, 2020 05:57PM

Joel, just some responses to your thoughts.

Monte 190 November 17, 2020 09:26PM



Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 34
Record Number of Guests: 1023 on May 05, 2021