Welcome! Log In Create A New Profile

Advanced

Re: Thx for sharing

November 19, 2020 03:35AM
First of all, I want to say that I am satisfied that the Spectra Vision on the correct setting and the coil proved to be a deep machine ... and a sensitive machine also for jewelry, and a good ID in multifrequency .. it is a detector you can trust ....

Now to the Spectry Vision Ground filters ... yes I tried the highest Ground Filter 12.5Hz High - but it was really shallow ....

Ground filters 12.5 Hz Band and 10 Hz Band proved to be deep enough when using TX Bost ON ... with controlled sweeping of the coils .... the right fast movement of the coils was, very, very important ...

I'm still talking ... that Whites should have written in the manual that the position of TX Bost ON in 3F multifrequency is "Basic detection mode with Spectra" and the use of Spectra without Bost is as "Eco detection mode" with reduced power. suitable for extra very demanding terrain ..

Because in the Normal mode, detectors lose the best performance and sensitivity of the detector ...

Note that after capturing the target, it helps a lot to sweep the coils over the target, which can significantly improve the signal of a good target.

Low Ground filters 5 Hz and 7.5 Hz could not work lespsies here, the results were only worse, and especially unreliable .. they could not be used here ..
-------------------------------------------------- -------------------------------------------------- -

now for separation .... on the coil of the Mars Sniper 6x10 ellipse I could get better separation results on some targets using Recovery delay 15 .. but on the other hand I lost signals on some more deep coin targets .... so mom again returned to the optimal setting of the recovery delay to 30..what gave - the best signal .. for most tested target ..

Recovery delay 60 turned out to be on many targets than less effective because the terrain is polluted with iron and minerals - the signals were less stable and accurate ..., and only on some tested more isolated targets turned out to be a bit better ..

... BUT ..I decided to try the limit speed recovery delay spertes over the Deposit of 1 pound / 450 grams / silver at a depth of 85 cm ... Sprectra still managed to capture such a signal even during recovery delay 10 ....

What was interesting in this * 3F spectrograph gave the best response frequency of 22.5 khz and partly 7.5 khz ... so I tried Spectra on 1F 22.5 khz and I also got a good signal ... even though this time can pass partly to FE Wrap..because Spectra transmits significantly sharper TX on 1F than on 3F multifrequency .....

That's why I consider 3F multifrequency Bost ON in combination with lower./ 5-8 RxGain / as standard Mode ... in Spectra Vision / V3.
.................................................. .................................................. ..................

Now to Alterov71 v2 .... it's a very effective detector with Mix mode and fully comparable to the Best Detectors .. Mike .. as well as after using Alter after these tests he likes it among the Top 3 best VLF detectors ... / Minelab Equinox, XP Deus,Rutus Alter /-........./ Etrac / does not count for VLF ...

I rank it among the 4-5 Top Best Vlf Detectors in the Present ..
Subject Author Views Posted

Comparison Tests ... They can be interesting, and here's a 're-test' I'm doing.

Monte 111 November 16, 2020 05:54AM

A report of a lot of detectors using their 'standard' search coil.

Monte 77 November 19, 2020 07:46AM

Any Thoughts of tossing some Rusty Tin in the Mix ?

UtahRich 43 November 19, 2020 04:34PM

Rusty Tin? Yes, it's on the agenda.

Monte 51 November 19, 2020 05:15PM

Rusty Tin - the bane of the ghost towns.

UtahRich 28 November 20, 2020 01:48AM

Rich, my thoughts regarding your thoughts.thinking

Monte 31 November 20, 2020 05:40AM

Re: Rusty Tin? Yes, it's on the agenda. Attachments

Kickindirt 41 November 19, 2020 11:00PM

No, I'm not kidding, if you read what I said or implied.

Monte 31 November 20, 2020 04:08AM

Re: No, I'm not kidding <--- lol where's your sense of humor

OregonGregg 33 November 20, 2020 12:57PM

Where's your sense of individuality ?

UtahRich 32 November 20, 2020 04:15PM

Re: Where's your sense of individuality ?

OregonGregg 31 November 20, 2020 04:53PM

Exactly! Confront it, learn it and YOUR detectors, and the future will be brighter. N/T

Monte 21 November 20, 2020 08:08PM

Sending you a PM - winking smiley N/T

UtahRich 18 November 20, 2020 06:25PM

Well Thank ya....sent you one to. N/T

OregonGregg 18 November 20, 2020 07:00PM

Still busy testing, but will have two upcoming comparisons.

Monte 50 November 17, 2020 02:02PM

Re: Still busy testing, but will have two upcoming comparisons.

D&P-OR 51 November 17, 2020 03:22PM

OregonGregg being a pain in the behind again sad smiley

OregonGregg 68 November 16, 2020 08:09AM

Gregg, I think you forgot .....

Monte 69 November 16, 2020 01:31PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 65 November 16, 2020 12:46PM

What's going to happen with the M6 ?

UtahRich 69 November 16, 2020 06:59PM

Re: What's going to happen with the M6 ?

OregonGregg 71 November 16, 2020 07:09PM

Re: What's going to happen with the M6 ?

EL NINO 47 November 17, 2020 06:13AM

Re: What's going to happen with the M6 ?

OregonGregg 48 November 17, 2020 07:49AM

Handle angle

SvenS 35 November 17, 2020 05:56PM

Re: Handle angle

OregonGregg 30 November 17, 2020 06:33PM

Re: Come on down Gregg!!

Kickindirt 38 November 17, 2020 01:39PM

Re: Come on down Gregg!!

OregonGregg 27 November 17, 2020 02:33PM

Re: Come on down Gregg!!

Kickindirt 36 November 17, 2020 04:19PM

Re: Come on down Gregg!!

D&P-OR 39 November 17, 2020 05:29PM

Re: Come on down Gregg!!

Kickindirt 28 November 17, 2020 06:05PM

Re: Come on down Gregg!!

D&P-OR 31 November 17, 2020 07:18PM

Re: ya Del

Kickindirt 24 November 17, 2020 09:00PM

I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

Monte 33 November 17, 2020 02:15PM

Re: I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

OregonGregg 32 November 17, 2020 02:37PM

Re: I just checked NOAA, and 32° at 12:56 in the afternoon it isn't likely Gregg will head your way.

D&P-OR 37 November 17, 2020 03:08PM

Did I read this correctly? Meet at Del & Patsy's for a winter long hunt ?

UtahRich 23 November 18, 2020 09:42PM

Re: Come on down Gregg!!

D&P-OR 38 November 17, 2020 01:45PM

Re: Come on down Gregg!!

OregonGregg 32 November 17, 2020 02:34PM

Re: What's going to happen with the M6 ?

Kickindirt 75 November 16, 2020 08:53PM

Re: What's going to happen with the M6 ?

OregonGregg 55 November 16, 2020 09:23PM

Re: What's going to happen with the M6 ?

Kickindirt 51 November 16, 2020 10:23PM

Here ya go

OregonGregg 51 November 16, 2020 10:42PM

That's not the response I expected . . . . . thinking

UtahRich 50 November 16, 2020 09:10PM

Re: That's not the response I expected . . . . . thinking

D&P-OR 49 November 16, 2020 09:25PM

So is Patsy there too ?

UtahRich 45 November 16, 2020 09:30PM

Re: So is Patsy there too ?

D&P-OR 44 November 16, 2020 09:42PM

Dinner Bell

UtahRich 44 November 16, 2020 09:44PM

confused smiley

UtahRich 49 November 16, 2020 08:32PM

The M6 - We need some clarification with your results.

UtahRich 58 November 16, 2020 07:14PM

Re: The M6 - We need some clarification with your results.

OregonGregg 59 November 16, 2020 08:11PM

OregonGregg being a pain in the behind again sad smiley

UtahRich 53 November 16, 2020 10:38AM

Rich, a few comments back to you.

Monte 67 November 16, 2020 01:21PM

What's Your Detector IQ ?

UtahRich 47 November 16, 2020 07:40PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 47 November 16, 2020 12:17PM

Re: OregonGregg being a pain in the behind again sad smiley

Druid 40 November 16, 2020 11:28PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 39 November 17, 2020 05:46AM

Re: OregonGregg being a pain in the behind again sad smiley

Druid 22 November 18, 2020 12:00PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 26 November 18, 2020 02:54PM

Re: OregonGregg being a pain in the behind again sad smiley

EL NINO 30 November 18, 2020 01:39PM

This machine looks familiar

zincoln 20 November 18, 2020 04:05PM

Re: This machine looks familiar

EL NINO 26 November 18, 2020 08:45PM

Thx for sharing

zincoln 21 November 18, 2020 10:44PM

Re: Thx for sharing

EL NINO 24 November 19, 2020 03:35AM

Setting Up Tests for your own detectors -

UtahRich 50 November 16, 2020 07:30PM

Agree 100%

OregonGregg 44 November 16, 2020 11:08AM

Customizing a Test -

UtahRich 51 November 16, 2020 06:52PM

Re: Agree 100%

Kickindirt 56 November 16, 2020 05:57PM

Joel, just some responses to your thoughts.

Monte 28 November 17, 2020 09:26PM



Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 8
Record Number of Guests: 632 on November 18, 2020