Welcome! Log In Create A New Profile

Advanced

Re: Some Q & A regarding your Tesoro Outlaw & DD coil issues.

April 16, 2017 01:48PM
Quote
Monte
Why would my 12x10 DD coil, on my Tesoro Outlaw, be less sensitive than the 8 inch donut?.Q: If you would, please describe what you mean by "less sensitive?"

A: Depending upon 'how' or 'what' you consider 'sensitive' to be, there can be a variety of possible answers. For example, some might consider 'sensitivity' to be depth of detection. Other might consider 'sensitivity' to be the ability to give a good response on a tiny-sized object. Still, others might view 'sensitivity' as how loud or strong a signal might be. Then, too, I hear some relate 'sensitivity' as the ability to respond to favorable targets in a densely littered site.



Therefore, to provide a useful answer, it's good to know what particular aspect of 'less sensitive' I need to relate to.

Bad term on my part. I meant Strong signal.

The sounds from the DD are very choppy, even on shallow coins. The sounds clear up a bit if the coil sweep is sped up..Q: Is this a condition you experience in a somewhat clean area w/o nearby trash?

Q: When you say "even on shallow coins" are you sweeping over coin that are within 2" of the search coil, especially those just an inch or so?

Typically about 4 to 6 inches. Some bad wording again.

Another interesting fact is that I cannot get the coil to Power Balance. Even if the Sensitivity is maxed out.Comment: Technically, you can't get the Outlaw to 'Power Balance' when using that particular search coil.

Q: Have you tried to 'Power Balance' that Outlaw with a different search coil?

Yes, with the 8 inch.

A: If you have tried to, and were successful, then the issue is most logically a problem with the 10X12 DD search coil.

A: If you tried, but failed to achieve a functional 'Power Balance,' then there is either a problem with that particular Outlaw, or you don't quite understand the steps to properly 'Power Balance' while in the silent-search Discriminate mode.

I think I'm comfortable with the Power Balance steps, you helped walk me thru.

There could be an issue with the Outlaw, it stays in AM mode at times even after the switch is moved to Disc. Also in AM/No Motion the detector detunes very quickly, say 5 to 10 seconds.


Comments: Always be sure there are no metal objects in the area of ground where you want to adjust the GB in the Disc. mode. Remember, too, to bob the search coil from about 8" down to maybe 1"-2" when 'Power Balancing' and a slower bobbing motion. Larger-size coils see more ground and with the dynamics of a DD design it can sometimes be a little noisy when adjusting.

If you did everything correct and the Outlaw is in fine working order, and you pressed and released the Pinpoint button when in the Disc. mode before starting the GB procedure, then I would think it is a search coil issue.

Monte

Thank you.
Subject Author Views Posted

DD Confusion...

Pablo61 169 April 15, 2017 04:31AM

Some Q & A regarding your Tesoro Outlaw & DD coil issues.

Monte 155 April 16, 2017 08:47AM

Re: Some Q & A regarding your Tesoro Outlaw & DD coil issues.

Pablo61 129 April 16, 2017 01:48PM

Answers to your answers.

Monte 135 April 18, 2017 09:35AM

Re: Answers to your answers.

Pablo61 92 April 18, 2017 12:58PM

Search coil 'dynamics.'

Monte 124 April 18, 2017 03:38PM

Re: Search coil 'dynamics.'

Pablo61 89 April 18, 2017 09:54PM

Re: DD Confusion...

johnedoe 124 April 15, 2017 05:32AM

Re: DD Confusion...

Pablo61 122 April 15, 2017 01:22PM

Re: DD Confusion...

WM6 141 April 17, 2017 11:49AM

Re: DD Confusion...

Pablo61 97 April 17, 2017 07:41PM

Re: DD Confusion...

WM6 101 April 18, 2017 05:27PM

Re: DD Confusion...

Pablo61 87 April 18, 2017 09:34PM

Re: DD Confusion...

WM6 107 April 18, 2017 04:54PM

Re: DD Confusion...

Pablo61 98 April 19, 2017 02:29PM

Re: DD Confusion...

WM6 111 April 19, 2017 07:49PM

Re: DD Confusion...

Pablo61 98 April 20, 2017 11:34AM

Re: DD Confusion...

WM6 118 April 20, 2017 06:15PM

Re: DD Confusion...

Pablo61 112 April 20, 2017 11:08PM



Sorry, only registered users may post in this forum.

Click here to login

Online Users

Guests: 14
Record Number of Users: 5 on January 14, 2014
Record Number of Guests: 182 on September 16, 2016